Error code
LG washer · IE
LG washer IE Error Code
Water inlet error — the tub isn't filling.
Easy fix · 10–20 minA washer never drains completely, and the water left in its pump, valves and hoses is what a cold garage night breaks. What LG, Samsung and Whirlpool say about freezing temperatures, how they tell you to winterize, and what to do if the machine is already frozen.
A washer can live in an unheated garage only if it never freezes, and the manufacturers are blunter about that than most garage-laundry advice. Samsung’s US installation page says the ambient temperature should always be above freezing, 32°F. Whirlpool tells owners to install and store the washer where it will not freeze. LG goes further and says the warranty is invalidated if the washer is exposed to below-freezing temperatures without protection. If your garage drops below freezing, the realistic choices are to keep the space above 32°F, to winterize the washer and stop using it for the cold months, or to move the laundry indoors. The dryer has its own, quieter set of cold-weather problems, covered further down.
An empty-looking washer is not dry inside. Whirlpool notes that some water stays in the hoses after every cycle. LG names the pump and hoses and explains the mechanism plainly: the residual water freezes, expands and damages the parts it sits in. The likely spots are the fill hoses between the faucet and the machine, the inlet valve where they connect, the drain pump and its filter housing at the bottom of a front-loader, and the drain hose, especially where it sags into a loop. These are exactly the places that crack, and a cracked fill hose or valve may not show itself until the next time the water is turned on, often on a warm day weeks later.
Garages add their own twist. The faucets that feed the washer are often on an outside wall, so the supply side can freeze before the machine does. That house plumbing is outside the scope of this site; what follows is about the appliance and its own hoses.
| Brand | What the source says | Winterizing method it gives |
|---|---|---|
| Samsung (washer installation page) | Ambient temperature should always be higher than freezing (32°F) | Not on this page; follow your model’s manual |
| Whirlpool (washer winter storage care) | Install and store where it will not freeze; no temperature figure given | 1 quart (1 L) of RV-type antifreeze, Rinse & Spin for about 30 seconds |
| LG (how to winterize a washer) | Protect from freezing in an unheated space; warranty invalidated if exposed below freezing without protection | 1 gallon of non-toxic RV antifreeze, spin-only for 1 minute |
Note what the table does not say. None of these sources gives a number of cold nights a washer can survive, and none says a garage is acceptable as long as it is “usually” above freezing. The difference in antifreeze amounts is real too: one quart in Whirlpool’s procedure, one gallon in LG’s. Use the amount in the procedure for your brand, and always the non-toxic RV type both name, never automotive antifreeze.
Close both supply faucets. Whirlpool and LG both start here.
Unplug the washer, take the inlet hoses off and let them drain into a bucket or shallow pan.
LG drains the remaining water through the pump filter into a shallow pan, then tilts the washer about 6 inches to clear the pump, and advises two people for the tilt. Washers are heavy; do not tilt one alone.
Whirlpool: 1 quart in the basket, Rinse & Spin for about 30 seconds. LG: 1 gallon in the empty drum, spin-only for 1 minute. The short spin mixes antifreeze with the water left in the pump; LG notes that not all of it is removed.
Unplug the washer. LG’s optional step for a long absence is to leave the hoses off, the cord unplugged and the circuit breaker off until you return.
Getting it back into service is the part people skip. Whirlpool’s sequence is to flush the pipes and hoses, reconnect them, turn on the faucets, plug in, and run the Bulky/Sheets and Deep Water Wash cycle with HE detergent at half the usual medium-load dose to wash out the antifreeze. LG’s version is to run water through the hoses, then a full cycle with no laundry but with HE detergent. Either way, check every hose connection for drips during that first fill, because that is when a crack from the winter shows up.
The machine usually tells you. LG’s top-load support page lists three displays: FF for freeze detection, IE when the supply hose or faucet is frozen and no water comes in, and OE when the drain hose or drain is frozen and the washer cannot empty. Our pages on the LG IE and OE codes cover the non-freezing causes of the same messages. A Whirlpool or Samsung washer will typically show its own fill or drain fault instead, because the board only knows that water did not arrive or did not leave.
The slowest fix is also the gentlest: LG notes that a frozen washer clears on its own once temperatures stay above freezing (0 °C, 32°F) for a reasonable time. If you cannot wait, LG’s owner method is warm, not boiling, water: 50 to 60 °C (about 122 to 140 °F) poured into the empty tub with the door closed for one to two hours, a towel soaked in warm water around the drain hose, a hot towel around the faucet for about five minutes, and supply hoses, disconnected from the faucet, thawed with water no hotter than 50 °C (122°F) before they go back on. LG warns specifically against boiling water because of the burn risk, and reminds you not to swap the hot and cold hoses when reconnecting. After thawing, it runs Spin Only to clear the water left inside, then a Rinse and Spin to confirm that the washer fills and drains normally.
A vented dryer holds no water, so it does not crack in the cold, but it does not like it either. Dryer installation instructions usually have a Location Requirements section, and some of them set a minimum room temperature for operating the dryer or warn that automatic cycles behave differently in the cold. That figure, if your model has one, is the number to respect; it is not the same for every dryer, so read it in your own document. LG’s dryer code list describes the cold-weather version of a sensor fault: tE2, a thermistor reading normally seen in cold conditions when outside air comes back into the dryer through an open exhaust vent. Its owner steps are to keep the outdoor vent flaps and louvers clear of snow, ice and frost so they open fully and close properly, and to warm the empty dryer on another cycle for a few minutes before starting the load; if tE2 keeps returning after that, LG says the dryer may need service. Steam models add a water line, and LG’s E05 entry asks you to confirm that the tap feeding it is not frozen.
The manufacturers do not publish a safe number of cold nights. Samsung’s requirement is simply that the space stays above 32°F, and LG ties warranty coverage to protecting the washer from freezing.
Not without reversing the process: reconnecting, flushing and running the cleaning cycle. Winterizing is meant for a washer that will sit unused in the cold.
Both Whirlpool and LG tell you to run an empty cycle with HE detergent before the first load, so the antifreeze is washed out before laundry goes in.
Not necessarily. Ventless and condensing dryers handle water internally; follow the cold-location section of that model’s manual rather than vented-dryer advice.
Sources: According to the manufacturers; figures apply to the products and pages named, and your model’s Use & Care Guide takes precedence.
Samsung US: Install a Samsung washing machine in your home — checked 2026-11-05.
Whirlpool Product Help: Winter Storage Care — Washer — checked 2026-11-05.
Whirlpool Product Help: Winter Storage Care — Front Load Washer — checked 2026-11-05.
LG USA: How to winterize a washing machine — checked 2026-11-05.
LG USA: Top load washer frozen, no water supply or drainage — checked 2026-11-05.
LG USA: Dryer — Error Code List — checked 2026-11-05.
A frozen supply hose looks to the washer like any other fill problem. Work through the fill checks once everything has thawed.
Error code
LG washer · IE
Water inlet error — the tub isn't filling.
Easy fix · 10–20 min
Error code
Error code
LG dryer · tE1
Thermistor error — the dryer's temperature sensor reported a problem.
Moderate
Error code
LG washer · UE
Unbalanced load — the drum can't spin evenly.
Easy fix · 10–20 min
Guide
Symptom guide
A washer that walks across the floor and a washer that leaves a puddle often share a cause: installation. Where to…
Guide
Symptom guide
Musty, sewage-like or burning: each washer smell points to a different source. How to tell them apart, what to clean,…
Thank you! Your feedback helps us make this page better.
Could not send. Please try again.