Guide
Symptom guide
Washer and Dryer in an Unheated Garage: Freeze Damage and What the Manuals Actually Require
A washer never drains completely, and the water left in its pump, valves and hoses is what a cold garage night breaks.…
Musty, sewage-like or burning: each washer smell points to a different source. How to tell them apart, what to clean, the drain-hose detail most people miss, and the habits that keep the odor from coming back.
A smelly washer is rarely broken. In most homes the odor comes from one of three things: a film of detergent and fabric softener that never fully rinses away, water left standing in a closed drum or door seal, or a drain hose that lets wastewater flow back in. Your nose can usually tell you which one you are dealing with, and that saves you from running a cleaning cycle against a problem it cannot fix. A musty, damp-basement smell is a residue and moisture problem. A rotten-egg or sewer smell more often points at the drain connection. A burning smell is a separate case with its own rules.
Short answer
Musty means residue and trapped moisture; sewage means the drain hose or the drain itself; burning on a new washer is often normal for the first cycles, and anything after that needs service.
| What you smell | Most likely source | Where to start |
|---|---|---|
| Musty, mildew, sour towels | Detergent and softener film, wet door seal, closed door between loads | Clean the drum and seal, then change habits |
| Sewage, sulfur, rotten eggs | Drain hose pushed too far into the standpipe, so water siphons back; sometimes the household drain | Check how deep the hose sits |
| Burning, hot electrical | Motor coating on the first cycles of a new washer; otherwise a fault | Stop and request service if it persists |
| Smell only on clean clothes | Laundry left wet in the drum, overloading, too much detergent | Unload promptly, reduce dose |
Modern high-efficiency washers use little water, which is exactly why they are sensitive to extra soap. Samsung’s support page on washer odors names detergent overuse as a cause of soap scum in the outer tub, the part you cannot see, and lists fabric softener as an added contributor. That film holds lint and moisture, and between loads it starts to smell. Front-load machines add a second trap: the rubber door seal folds into a pocket where water, hair and small items collect.
So the fix has two halves. First, clean what is already there. Samsung’s procedure for mold or mildew, written for its own washers, is to run a Spin-only cycle with an empty tub, pour liquid chlorine bleach into the detergent compartment up to the max line (the detergent compartment, not the bleach one), then immediately start the Self Clean, Self Clean+ or Pure Cycle. It notes the cycle takes about an hour on top loaders and around four hours on front loaders. After that, wipe the tub, run Rinse+Spin, and repeat until there is no visible residue. Other brands have their own tub-clean cycles and approved cleaners; our guide to washer clean cycles explains the messages and the limits by model.
Second, stop feeding the film. Use HE detergent and stay below the max line or the dose the detergent maker gives for the load. Samsung even suggests a simple test: run an empty cycle with no additives, and if suds appear, keep running empty cycles until they stop. Suds on an empty cycle are leftover detergent, and they tell you the dose has been too high. If you see heavy foam during normal washes as well, the separate guide on too many suds covers that symptom and the codes some washers show for it.
A sulfur or sewer smell that the cleaning cycle does not touch often has nothing to do with the drum. Samsung explains the mechanism: when the drain hose is inserted too deep into the standpipe, drained water can siphon back into the washer and sit there. Its leak page puts the hose 6 to 8 inches into the pipe, warns that deeper than 8 inches causes siphoning, and adds that the hose must not form an airtight seal with the pipe; the odor page is stricter and suggests no more than 6 inches. Pull the hose out, clean its end if needed, reinsert it to the right depth and secure it. Leave the factory hose holder on the back of the washer in place; Samsung says not to remove its screw.
If the hose is fine and the smell still seems to come from the laundry area, think about the drain itself. A standpipe or floor drain that rarely gets water can smell regardless of the washer, and that is a job for a plumber, not for another tub-clean cycle. Slow draining that leaves water in the tub is a related problem; the washer-won’t-drain guide walks through it.
Many front-load washers have a pump filter behind a small panel at the bottom front. It catches lint, coins and hair, and the water trapped around it can smell strongly. Samsung recommends cleaning it at least once a month or every 40 washes, whichever comes first. Expect water to come out: put a shallow container and towels down, drain the hose into the container, then remove and rinse the filter. Top-load and other models may not have an owner-serviceable filter, so check the manual before you look for one.
Samsung says a burning smell during the first couple of cycles of a new washer is normal and comes from the insulating coating on the motor coils; it should fade. If it continues after those first cycles, or appears suddenly on a washer that never smelled before, stop using the machine and request service. A washer does not need cleaning for a burning smell, and it should not be run again and again to see whether the smell goes away.
Wet laundry left in a closed drum is the fastest way to a sour smell, on clothes and in the washer.
Let the drum, seal and dispenser dry between loads, where children and pets cannot get in.
On front loaders, fold back the gasket and wipe out water, hair and lint with a dry cloth.
Measure detergent, do not fill to the brim, and skip liquid fabric softener if odors keep returning.
Samsung suggests about once a month or every 30 to 40 loads, when the reminder appears; follow your own manual.
If you have cleaned the drum, the seal and the filter, fixed the hose depth and changed the detergent habit, and the odor still returns within a few loads, the source may be inside parts of the drain system you cannot reach. Samsung’s advice at that point is to request service. Write down the model number, what kind of smell it is and when it appears, so the technician can start from facts.
Some manufacturers allow distilled white vinegar in specific cycles, and Samsung mentions it instead of fabric softener. Check your manual, and never use it in the same cycle as chlorine bleach.
Front loaders seal tightly and use little water, so residue and trapped moisture have nowhere to go unless you leave the door open and wipe the gasket.
Usually not. Cleaning plus better habits fixes most musty odors. Service makes sense when the smell persists after several attempts.
Laundry that sits wet, an overloaded drum or too much detergent can all leave odor in fabric. Try smaller loads, the right dose and prompt unloading.
Sources: every number above comes from Samsung’s US support pages; other brands may give different intervals and cycle names in their manuals.
Samsung US: Samsung washing machine or laundry smells bad — checked 2026-11-05.
Samsung US: Samsung washing machine is leaking — checked 2026-11-05.
See what Tub Clean, Self Clean and the reminder messages mean on your washer.
Guide
Symptom guide
A washer never drains completely, and the water left in its pump, valves and hoses is what a cold garage night breaks.…
Guide
Symptom guide
Use LG Tub Clean, Samsung Self Clean or Whirlpool Clean Washer with an empty drum, the correct model instructions and…
Guide
Symptom guide
Compare LG Sud, Samsung SUd and Whirlpool Sud/Sd without assuming the same pause, cleaning cycle or dispenser…
Guide
Symptom guide
Water remains in the washer? Match the drain code and model before inspecting a hose or using an owner-accessible filter…
Guide
Symptom guide
A washer that walks across the floor and a washer that leaves a puddle often share a cause: installation. Where to…
Error code
LG washer · UE
Unbalanced load — the drum can't spin evenly.
Easy fix · 10–20 minThank you! Your feedback helps us make this page better.
Could not send. Please try again.