Error code
LG dryer · tE1
LG dryer tE1 Error Code
Thermistor error — the dryer's temperature sensor reported a problem.
ModerateWhat it means
Exhaust vent about 80% restricted — clean the duct.
Easy fix · 30–60 minLG dryers with Flow Sense watch the airflow through the exhaust duct. The codes d75, d80, d90 and d95 mean the duct is roughly 75, 80, 90 or 95 percent restricted. LG says that at d90 and d95 the dryer should not be used until the exhaust system has been cleaned and repaired. LG also notes that on gas dryers a d80 code can point to a lack of gas supply. A restricted vent makes drying slow and the dryer hotter — and lint in the duct is a fire risk.
| Cause | Difficulty |
|---|---|
| Lint built up in the exhaust duct behind the dryer | Easy fix |
| Full lint screen | Easy fix |
| Foil or vinyl duct crushed or kinked behind the dryer | Easy fix |
| Outside vent hood blocked by lint, a stuck damper or a nest | Easy fix |
| Duct run too long or with too many bends | Call a pro |
| Gas dryer: gas supply valve closed or low gas supply | Call a pro |
Remove the lint, and wash the screen with warm soapy water if it looks clogged with residue from dryer sheets.
Pull the dryer out, disconnect the duct and look for lint and crushed sections. Clean it with a vent brush; replace a crushed foil duct with a rigid or semi-rigid metal duct.
With the dryer running, go outside: you should feel strong airflow and the damper should open. Clear lint from the hood.
Reconnect the duct without kinks, push the dryer back without crushing it and run a timed dry cycle.
LG’s steps stop at the lint tray, the reachable duct and the outdoor flap. The full owner checklist and what a vent service does are in one guide.
d80 is a warning: clean the vent as soon as you can. At d90 and d95 LG says not to use the dryer until the exhaust is cleaned, and a clogged duct is a fire risk.
Check the whole run, including the outside hood and any bends in the wall. A long duct with several elbows can restrict airflow even when it is clean.
Sources: According to the manufacturer: LG USA dryer code list, checked 2026-10-11. Codes can differ between model generations — check the troubleshooting table in the owner's manual of your model.
Error code
LG dryer · tE1
Thermistor error — the dryer's temperature sensor reported a problem.
Moderate
Error code
LG dryer · PS
Power supply error — improper voltage at the power cord.
Call a pro
Error code
Samsung dryer · tC
A temperature or temperature-sensor issue has been detected.
Check model first
Error code
Samsung dryer · HC
Heating error, generally excessive heat; Samsung also notes a low-voltage exception on electric dryers.
Call a pro
Error code
Samsung dryer · dC
A door, latch or door-detection problem.
Check model firstDryers
LG dryer codes by family: door, humidity sensor, temperature sensor, airflow and power, plus the Add Water and Child…
Dryers
Find ten Samsung dryer code pages, including oD dry-time reporting, with model-specific safe checks, service limits…
Guide
Symptom guide
Distinguish no heat from warm but damp clothes, check the model’s cycle settings and accessible lint areas, and leave…
Error code
Samsung dryer · 9C1
Samsung groups 9C1 with supply-voltage warnings; some stacked multi-control installations have a specific software exception.
Call a pro
Error code
Samsung dryer · bE
A control-panel button is being detected as stuck or continuously pressed.
Check model first
Error code
Samsung dryer · AC
Internal dryer components are not communicating with each other as expected.
Call a pro
Error code
Samsung dryer · FC
The dryer reports an invalid power-source frequency; Samsung also lists FE and 1 FC in this group.
Call a pro
Error code
Samsung dryer · 3C
Samsung lists 3C as a dryer motor error, with service required if the documented recovery does not resolve it.
Call a pro
Error code
Samsung dryer · HC2
Samsung lists HC2 as a gas-ignition error; the final 2 distinguishes it from the general HC heating group.
Call a pro
Guide
Symptom guide
A dryer that runs longer needs a check of the cycle, load and drying system. Use safe Samsung and LG references before…
Guide
Symptom guide
A powered dryer that will not start needs a code, Child Lock and door check. Use the Samsung timer test safely and…
Guide
Symptom guide
Read Samsung Vent Blockage test results with the correct model controls, a cool empty drum and safe next steps for…
Guide
Symptom guide
Samsung dryer dn means a firmware download is in progress. Leave power on, wait for the automatic restart and request…
Dryers
Compare covered LG and Samsung dryer warnings by reported system, with separate boundaries for vented, electric, gas and…
Error code
Samsung dryer · oD
Samsung identifies oD as a Dry Time Error and directs owners to a limited recovery followed by service if it returns.
Check model firstThank you! Your feedback helps us make this page better.
Could not send. Please try again.