Appliance Error Codes
Appliance code pages and brand references for washers, dryers, dishwashers and refrigerators, plus symptom guides and…
No error code, just a washer that leaks, a dryer that smells or a freezer that is soft? Start here: a triage that separates emergencies from everyday faults, then points each symptom to the right guide.
Most of this site is organized by error code, because a code is the most precise thing an appliance can tell you. But many problems arrive without one. The washer leaves a puddle, the dryer smells hot, the dishwasher hums and stays dry, the freezer is merely cool. In those cases the useful question is not “what does the code mean?” but “what kind of problem is this, and how urgent is it?” This page answers that in three passes: first the situations where you stop and call for help, then a short way to describe the symptom, and finally a map from each common symptom to the guide that deals with it.
A handful of signs override every troubleshooting step on this site. Smoke, a smell of gas, sparks, a hot or melted plug or outlet, a breaker that trips again as soon as it is reset, or water spreading toward an outlet or electrical panel are not symptoms to diagnose. For a gas dryer that smokes or smells of gas, Samsung’s instruction is to clear the building and call emergency services, without operating switches or using a phone inside. For an electric appliance that smokes or smells electrical, switch it off at the breaker if that is safe and request service.
Technicians and support lines think in a few categories, and putting your problem in one of them is half the diagnosis. Is it about water (none, too much, in the wrong place), about heat or cold (too much, too little), about motion (does not start, does not spin, shakes), about smell or noise, or about the result (dishes dirty, clothes wet)? Then add when it happens: at the start, mid-cycle, at the end, or all the time. “Dishwasher: water appears under the door, during the wash, with a new detergent” already rules out most causes. Write that line down; it also becomes the first sentence of a service request if you need one.
| Family | First question | Often points to |
|---|---|---|
| Water | Is water missing, excessive, or outside the appliance? | Supply valve, drain hose, seals, suds |
| Temperature | What does a thermometer actually read? | Settings, airflow, vents, door seal |
| Motion | Does it start, run, or stop at a particular stage? | Door lock, load balance, power, controls |
| Smell | Musty, sewage, burning or electrical? | Residue, drain siphoning, lint, fault |
| Noise | Is it new, continuous, or tied to one stage? | Normal operation, frost, level, foreign object |
| Result | Is the cycle finishing but the result poor? | Loading, detergent, filters, rinse aid |
Each guide below starts from the symptom and works through owner checks in a safe order, then states where service begins. If the display shows a code at any point, switch to the code page: it is more specific than any symptom guide. Washers first. A machine that will not drain, spin or fill, a door that will not unlock, foam everywhere, odors, puddles or walking across the floor each have their own page.
Dryers mostly come down to airflow and heat. A dryer that will not start is usually a door, control or power question; one that runs but stays cool, takes two cycles, or smells hot is far more often an exhaust problem than a broken heater. Because a blocked vent raises the fire risk, read the burning-smell guide before you run another load.
Dishwashers have a short water path and a lot of moving water, so their symptoms cluster around filling, draining and the door. Poor cleaning and wet dishes are usually loading, detergent and rinse-aid questions rather than faults.
Refrigerators are the one appliance where waiting has a cost, because food is involved. The FDA targets are 40 °F or below for the refrigerator and 0 °F for the freezer, measured with an appliance thermometer rather than read from the display. Start by measuring, then pick the guide for what you see: too warm, too cold, frost, moisture, noise, or a dispenser or ice maker that has stopped.
Procedures, buttons and even code meanings differ by model. Our guide shows where the label hides on each appliance.
If you level the washer and change the detergent at once, you will not know which fixed it, or whether either did.
Refrigerators can take a day to settle after a change; a reset needs the time the manufacturer specifies. Our power-reset guide explains why.
If the owner checks do not solve it, the notes you made in pass 2 are what a technician needs: the model, the symptom, when it happens, what you already tried and what changed. A clear description often decides whether the first visit ends with a repair or with a second appointment.
The code. It is the appliance’s own report and is usually more specific. Use the symptom guide for context.
Only after the urgent checks and only as the manufacturer describes. A reset can clear a code you need for diagnosis.
Use the symptom families above to describe it, check the code catalog for your brand, and contact the manufacturer with your notes.
Sources: emergency and food-temperature guidance from the manufacturer and the FDA.
Samsung US: Samsung dryer smells or smokes — checked 2026-11-05.
FDA: Refrigerator Thermometers: Cold Facts about Food Safety — checked 2026-11-05.
Look it up by brand and appliance in the full catalog.
Appliance code pages and brand references for washers, dryers, dishwashers and refrigerators, plus symptom guides and…
Symptom guide
A good fault description saves a second visit. What to write down before you call: the exact display, the conditions,…
Symptom guide
Unplugging an appliance is the most common advice online and the least understood. What a power reset clears, what it…
Thank you! Your feedback helps us make this page better.
Could not send. Please try again.