Find your code

Washer Clean Cycles: Tub Clean, Self Clean and rL

Use LG Tub Clean, Samsung Self Clean or Whirlpool Clean Washer with an empty drum, the correct model instructions and clear limits for active faults.

By ApplianceCodeHQ Editorial Updated

Washer Clean Cycles: Tub Clean, Self Clean and rL
In this guide
  1. What each covered message means
  2. Model and chemical limits
  3. Prepare a safe maintenance cycle
  4. Reminders are not component diagnoses
  5. Frequently asked questions

A washer maintenance cycle cleans the appliance rather than a load of clothing. Names such as Tub Clean, Self Clean, Pure Cycle and Clean Washer describe different manufacturers’ programs; they do not establish one shared cleaner recipe. First decide whether you have a maintenance reminder or an active leak, drain or overflow error. Routine cleaning should not be used as a test for a machine that cannot operate safely.

What each covered message means

Maintenance reminders and fault warnings require different responses
Brand and supported contextHow to interpret it
LG front-load tcL / Tub Clean A prompt or selected maintenance cycle; follow the model’s empty-drum instructions.
Samsung Self Clean / Pure Cycle A maintenance program; the reminder and controls depend on the model.
Whirlpool front-load F0 E1 or rL during Clean Washer Items were detected when the maintenance cycle should be empty.
Any brand with an active leak or overflow Stop and address the fault before running maintenance.

Appliance water use comparison

Compare documented gallons per cycle at the same workload.

Compare water use

Model and chemical limits

LG’s current general front-loader guide describes an oxygen-based cleaner, while older model manuals can give different approved-product instructions. Samsung’s routine Self Clean directions say cleaner is not needed and separate out an existing-mold procedure. Whirlpool’s rL entry addresses removing a load, not a universal chemical dose. Use the exact US manual and the approved product’s directions together. Do not borrow a bleach dose or detergent compartment from a different model.

Prepare a safe maintenance cycle

  1. Confirm the program and model

    Locate the appropriate owner instructions. Samsung Bespoke AI Laundry Combo maintenance has its own guide; a standard washer procedure may not match.

  2. Remove all laundry

    The covered maintenance cycles require an empty drum. Do not use towels as a cleaning aid or leave a small garment inside.

  3. Use only the specified product, if any

    For routine Samsung Self Clean, the cited guidance does not require an added cleaner. For a model that calls for a product, use its approved placement and measured dose.

  4. Allow the selected program to finish

    Follow the displayed time and model controls. Stop for leakage or a new fault instead of repeatedly restarting.

  5. Inspect the result from normal access

    Note persistent foam, residue or odor. Clean only owner-removable components as the manual permits; do not reach into a hot drain system.

Reminders are not component diagnoses

Samsung describes reminder counts of twenty top-load washes or forty front-load washes in its general guidance and recommends periodic cleaning even with lighter use. Those counts do not prove contamination or failure of a sensor. LG’s tcL reminder likewise should not be relabeled a motor or drain fault. A returning Whirlpool rL with a genuinely empty drum needs support rather than progressively larger doses of cleaner.

Frequently asked questions

Can I run a cleaning cycle with laundry inside?

No. These covered maintenance procedures require an empty drum.

Does every cleaning cycle require bleach?

No. The approved product and whether any additive is needed vary by model and purpose.

Will cleaning fix an active overflow code?

Do not use it as an overflow test. Make the fault safe first and follow its own service guidance.

Sources: According to the manufacturer for appliance behavior; this is not an independent diagnosis.
LG USA: Front Loader — How to Clean the Tub — checked 2026-10-22.
Samsung US: How to clean your washer — checked 2026-10-22.
Whirlpool US: F0 E1 or rL — Front Load Washer — checked 2026-10-22.

Related codes, guides and tools

Use the actual model and full display before choosing a procedure.

Related display and dispenser guidance

Match the complete display and model before choosing the next step.

Related codes & guides

Error code

LG washer · UE

LG washer UE Error Code

Unbalanced load — the drum can't spin evenly.

Easy fix · 10–20 min
Error code

LG washer · OE

LG washer OE Error Code

Drain error — water isn't draining.

Easy fix · 20–30 min
Error code

LG washer · IE

LG washer IE Error Code

Water inlet error — the tub isn't filling.

Easy fix · 10–20 min
Error code

Samsung washer · LC

Samsung washer LC Error Code

Water level or leak error — water is detected where it doesn't belong.

Moderate
Chart

Washers

LG Washer Error Codes

Browse eighteen LG washer code pages, including distinct Ed1/Ed2 detergent warnings and ezDispense Ed5, with model…

Chart

Washers

Washer Error Codes by Brand

One chart for the common washer problems — drain, fill, unbalanced load, door, leak — and the code LG, Samsung and…

Error code

LG washer · dE

LG washer dE Error Code

The door has not closed or locked as required.

Check model first
Error code

LG washer · LE

LG washer LE Error Code

The tub cannot spin; LG identifies overload or an object in the tub as possible reasons.

Check model first
Error code

LG washer · PE

LG washer PE Error Code

LG reports a problem with the water-level sensor.

Call a pro
Error code

LG washer · tE

LG washer tE Error Code

Heating error; LG associates it with the thermistor that senses temperature.

Call a pro
Error code

Samsung washer · dC

Samsung washer dC Error Code

Model-dependent: a door error or an unbalanced-load error.

Check model first
Error code

Samsung washer · Ub

Samsung washer Ub Error Code

An unbalanced load prevented the cycle from completing.

Check model first
Chart

Washers

Samsung Washer Error Codes

Browse fourteen Samsung washer code pages with AC communication, 3C motor and tC sensing, model-dependent 3E meanings…

Chart

Washers

Whirlpool Washer Error Codes

Compare thirteen Whirlpool front-load code pages for water, doors, balance, foam and dispenser messages, with exact…

Error code

LG washer · Sud

LG Washer Sud Error Code

The washer has detected too much foam and is managing an oversudsing condition.

Check model first
Error code

LG washer · PF

LG Washer PF Error Code

Power was interrupted during operation; the display does not identify why the supply was lost.

Check model first
Error code

LG washer · CE

LG Washer CE Error Code

An overcurrent condition has been detected in the motor’s electrical circuit.

Call a pro
Error code

Samsung washer · OC

Samsung Washer OC Error Code

The washer reports an overflow condition: too much water is detected.

Call a pro
Error code

Samsung washer · 4C2

Samsung Washer 4C2 Error Code

The cold-water supply is unexpectedly hot; Samsung identifies reversed hot and cold connections.

Check model first
Error code

Samsung washer · SUd

Samsung Washer SUd Error Code

Excessive suds were detected; the washer pauses to let the foam settle before continuing.

Check model first
Error code

Whirlpool washer · F5 E1

Whirlpool Washer F5 E1 Error Code

Whirlpool identifies this front-load entry as a door-switch condition.

Check model first
Error code

Whirlpool washer · F5 E3

Whirlpool Washer F5 E3 Error Code

The cited Whirlpool front-load guidance says the door is not locking properly.

Check model first
Error code

Whirlpool washer · F7 E1

Whirlpool Washer F7 E1 Error Code

A motor-speed sensing error: the selected cycle speed is not being achieved.

Check model first
Error code

Whirlpool washer · Sud / Sd

Whirlpool Washer Sud / Sd Error Code

Excess suds are interfering with the wash or spin, so the washer adds rinsing and pauses.

Check model first
Error code

LG washer · dHE

LG Washer dHE Error Code

LG identifies a dry-function error on applicable washer-dryer equipment.

Check model first
Error code

LG washer · AE

LG Washer AE Error Code

The covered LG front-load entry reports internal leakage and activation of the leak-protection system.

Call a pro
Error code

LG washer · SE

LG Washer SE Error Code

LG’s front-load support describes SE as a sensor error requiring service if the limited restart does not resolve it.

Call a pro
Error code

Whirlpool washer · F0 E1

Whirlpool Washer F0 E1 Error Code

A load is detected while the Clean Washer maintenance cycle is selected; Whirlpool also lists rL for this condition.

Check model first
Error code

Whirlpool washer · F0 E5

Whirlpool Washer F0 E5 Error Code

The covered front-load washer reports an off-balance load, which can extend the cycle or reduce spin speed.

Check model first
Error code

Whirlpool washer · F8 E2

Whirlpool Washer F8 E2 Error Code

Whirlpool identifies a problem with the front-load washer’s dispenser system.

Check model first
Error code

Whirlpool washer · F8 E3

Whirlpool Washer F8 E3 Error Code

The washer reports an overflow condition involving too much water or foam.

Call a pro
Error code

Whirlpool washer · dET

Whirlpool Washer dET Error Code

The detergent dispenser cartridge is not detected on applicable cartridge-equipped front-load washers.

Check model first
Error code

LG washer · HE

LG Washer HE Error Code

According to LG, HE reports a heater error on the front-load models covered by its US guide.

Check model first
Error code

LG washer · vS

LG Washer vS Error Code

According to LG, vS concerns the vibration sensor; the display can resemble u5 or uS.

Check model first
Error code

Samsung washer · bE2

Samsung Washer bE2 Error Code

Samsung places bE2 in its stuck-button group, but BE2/8E2 means a MEMS sensor error on some models.

Check model first
Error code

Samsung washer · 9C1

Samsung Washer 9C1 Error Code

According to Samsung, 9C1 belongs to the washer electrical-supply irregularity group.

Call a pro
Error code

Samsung washer · ddC

Samsung Washer ddC Error Code

According to Samsung, ddC or dC3 means the Add Door is not detected as closed and locked.

Check model first
Error code

LG washer · Ed1 / Ed2

LG Washer Ed1 / Ed2 Error Code

LG identifies Ed1 and Ed2 as detergent-dispensing warnings, with different pump conditions reported.

Check model first
Error code

LG washer · Ed5

LG Washer Ed5 Error Code

LG identifies Ed5 as a communication problem involving the automatic detergent dispenser and its control system.

Check model first
Error code

Samsung washer · AC

Samsung Washer AC Error Code

Samsung lists AC as a washer communication error; the exact model determines the affected system.

Check model first
Error code

Samsung washer · 3C

Samsung Washer 3C Error Code

Samsung identifies washer 3C as a motor error. It does not by itself identify a failed motor or sensor.

Check model first
Error code

Samsung washer · tC

Samsung Washer tC Error Code

Samsung lists washer tC, tE and tE1 in its temperature-sensor error group.

Check model first