Find your code

Whirlpool Washer dET Error Code

By ApplianceCodeHQ Editorial Updated

dET

What it means

The detergent dispenser cartridge is not detected on applicable cartridge-equipped front-load washers.

Check model first

Jump to the fix

Applies to these models and systems

This page covers the Whirlpool US front-load washer entry linked below. It is not a top-load, commercial-laundry or dishwasher code definition. Match the complete model and display to the US owner’s manual before using a cycle, dispenser or clearing procedure. Whirlpool specifically references the Optimal Dispense Cartridge. This is not a claim about every Load & Go design or a detergent-low reminder.

Whirlpool Washer dET Error Code

What dET means

Whirlpool separates two situations: an automatic cartridge that should be present, and intentional single-load detergent dosing. The support page says the message may be ignored when using single-load doses. That exception does not mean every dispenser warning can be ignored. Confirm the dispensing mode and correct detergent placement in the exact manual so a load is not dosed twice.

Documented conditions and next steps

Manufacturer guidance; no failure probabilities assigned
ConditionWhat it means for your next step
The cartridge is intended to dispense detergent Check that the correct cartridge is installed and fully seated.
Intentional single-load dosing The cited dET entry allows this message to be ignored; follow that model’s single-load setup.
Drawer cannot close or a correctly installed cartridge is not recognized Do not force parts into place. Ask Whirlpool to assess the dispenser.

Safe checks before a repair

  1. Confirm dET and the full model

    Keep the case and all characters. Do not confuse cartridge detection with F8 E2 or a detergent-low message.

  2. Check the intended dosing method

    Read the manual’s automatic versus single-load instructions. Do not enable both and add extra detergent as an experiment.

  3. Seat the cartridge normally

    With the washer stopped, use the owner instructions to check insertion. Close the drawer completely without forcing it or modifying any latch.

  4. Observe the result

    If automatic dispensing is intended and dET remains, record what you checked and contact support. Use the single-load exception only as described for this model.

Frequently asked questions

Does dET mean I ran out of detergent?

Not in this cited entry. It means the cartridge is not detected; a low-detergent message is a different condition.

Can I use single-load detergent?

Whirlpool’s dET guidance explicitly allows that exception, with the model’s correct dosing and placement instructions.

Should I push harder on the drawer?

No. A drawer that will not close normally needs an obstruction or fit check, not force.

Sources: According to the manufacturer for appliance behavior; this is not an independent diagnosis.
Whirlpool US: dET — Front Load Washer — checked 2026-10-22.

Whirlpool Washer error codes

Keep the full model and complete display with the appliance type when choosing a procedure.

Open the reference

Related codes and next steps

Each reference has its own model and service limits.

Related codes & guides

Error code

LG washer · UE

LG washer UE Error Code

Unbalanced load — the drum can't spin evenly.

Easy fix · 10–20 min
Error code

LG washer · OE

LG washer OE Error Code

Drain error — water isn't draining.

Easy fix · 20–30 min
Error code

LG washer · IE

LG washer IE Error Code

Water inlet error — the tub isn't filling.

Easy fix · 10–20 min
Error code

Samsung washer · LC

Samsung washer LC Error Code

Water level or leak error — water is detected where it doesn't belong.

Moderate
Chart

Washers

LG Washer Error Codes

Browse eighteen LG washer code pages, including distinct Ed1/Ed2 detergent warnings and ezDispense Ed5, with model…

Chart

Washers

Washer Error Codes by Brand

One chart for the common washer problems — drain, fill, unbalanced load, door, leak — and the code LG, Samsung and…

Error code

LG washer · dE

LG washer dE Error Code

The door has not closed or locked as required.

Check model first
Error code

LG washer · LE

LG washer LE Error Code

The tub cannot spin; LG identifies overload or an object in the tub as possible reasons.

Check model first
Error code

LG washer · PE

LG washer PE Error Code

LG reports a problem with the water-level sensor.

Call a pro
Error code

LG washer · tE

LG washer tE Error Code

Heating error; LG associates it with the thermistor that senses temperature.

Call a pro
Error code

Samsung washer · dC

Samsung washer dC Error Code

Model-dependent: a door error or an unbalanced-load error.

Check model first
Error code

Samsung washer · Ub

Samsung washer Ub Error Code

An unbalanced load prevented the cycle from completing.

Check model first
Chart

Washers

Samsung Washer Error Codes

Browse fourteen Samsung washer code pages with AC communication, 3C motor and tC sensing, model-dependent 3E meanings…

Chart

Washers

Whirlpool Washer Error Codes

Compare thirteen Whirlpool front-load code pages for water, doors, balance, foam and dispenser messages, with exact…

Error code

LG washer · Sud

LG Washer Sud Error Code

The washer has detected too much foam and is managing an oversudsing condition.

Check model first
Error code

LG washer · PF

LG Washer PF Error Code

Power was interrupted during operation; the display does not identify why the supply was lost.

Check model first
Error code

LG washer · CE

LG Washer CE Error Code

An overcurrent condition has been detected in the motor’s electrical circuit.

Call a pro
Error code

Samsung washer · OC

Samsung Washer OC Error Code

The washer reports an overflow condition: too much water is detected.

Call a pro
Error code

Samsung washer · 4C2

Samsung Washer 4C2 Error Code

The cold-water supply is unexpectedly hot; Samsung identifies reversed hot and cold connections.

Check model first
Error code

Samsung washer · SUd

Samsung Washer SUd Error Code

Excessive suds were detected; the washer pauses to let the foam settle before continuing.

Check model first
Error code

Whirlpool washer · F5 E1

Whirlpool Washer F5 E1 Error Code

Whirlpool identifies this front-load entry as a door-switch condition.

Check model first
Error code

Whirlpool washer · F5 E3

Whirlpool Washer F5 E3 Error Code

The cited Whirlpool front-load guidance says the door is not locking properly.

Check model first
Error code

Whirlpool washer · F7 E1

Whirlpool Washer F7 E1 Error Code

A motor-speed sensing error: the selected cycle speed is not being achieved.

Check model first
Error code

Whirlpool washer · Sud / Sd

Whirlpool Washer Sud / Sd Error Code

Excess suds are interfering with the wash or spin, so the washer adds rinsing and pauses.

Check model first
Error code

LG washer · dHE

LG Washer dHE Error Code

LG identifies a dry-function error on applicable washer-dryer equipment.

Check model first
Error code

LG washer · AE

LG Washer AE Error Code

The covered LG front-load entry reports internal leakage and activation of the leak-protection system.

Call a pro
Error code

LG washer · SE

LG Washer SE Error Code

LG’s front-load support describes SE as a sensor error requiring service if the limited restart does not resolve it.

Call a pro
Error code

Whirlpool washer · F0 E1

Whirlpool Washer F0 E1 Error Code

A load is detected while the Clean Washer maintenance cycle is selected; Whirlpool also lists rL for this condition.

Check model first
Error code

Whirlpool washer · F0 E5

Whirlpool Washer F0 E5 Error Code

The covered front-load washer reports an off-balance load, which can extend the cycle or reduce spin speed.

Check model first
Error code

Whirlpool washer · F8 E2

Whirlpool Washer F8 E2 Error Code

Whirlpool identifies a problem with the front-load washer’s dispenser system.

Check model first
Error code

Whirlpool washer · F8 E3

Whirlpool Washer F8 E3 Error Code

The washer reports an overflow condition involving too much water or foam.

Call a pro
Error code

LG washer · HE

LG Washer HE Error Code

According to LG, HE reports a heater error on the front-load models covered by its US guide.

Check model first
Error code

LG washer · vS

LG Washer vS Error Code

According to LG, vS concerns the vibration sensor; the display can resemble u5 or uS.

Check model first
Error code

Samsung washer · bE2

Samsung Washer bE2 Error Code

Samsung places bE2 in its stuck-button group, but BE2/8E2 means a MEMS sensor error on some models.

Check model first
Error code

Samsung washer · 9C1

Samsung Washer 9C1 Error Code

According to Samsung, 9C1 belongs to the washer electrical-supply irregularity group.

Call a pro
Error code

Samsung washer · ddC

Samsung Washer ddC Error Code

According to Samsung, ddC or dC3 means the Add Door is not detected as closed and locked.

Check model first
Error code

LG washer · Ed1 / Ed2

LG Washer Ed1 / Ed2 Error Code

LG identifies Ed1 and Ed2 as detergent-dispensing warnings, with different pump conditions reported.

Check model first
Error code

LG washer · Ed5

LG Washer Ed5 Error Code

LG identifies Ed5 as a communication problem involving the automatic detergent dispenser and its control system.

Check model first
Error code

Samsung washer · AC

Samsung Washer AC Error Code

Samsung lists AC as a washer communication error; the exact model determines the affected system.

Check model first
Error code

Samsung washer · 3C

Samsung Washer 3C Error Code

Samsung identifies washer 3C as a motor error. It does not by itself identify a failed motor or sensor.

Check model first
Error code

Samsung washer · tC

Samsung Washer tC Error Code

Samsung lists washer tC, tE and tE1 in its temperature-sensor error group.

Check model first

Other codes