Find your code

Samsung washer 5C Error Code

By ApplianceCodeHQ Editorial Updated

5C

What it means

Water is draining too slowly or is not draining.

Check model first

Jump to the fix

Applies to these models and systems

Samsung US washers using 5C, 5E, nd or a listed equivalent. A removable pump-filter procedure applies to front loaders, not Samsung top loaders. Use your exact installation manual for hose dimensions.

Samsung washer 5C Error Code

What 5C means

Record whether water remains in the drum and whether the message appeared before the final spin. A drain error can explain a spin that never starts. It does not prove the pump needs replacement, and opening a filter with a full hot tub can make the situation worse.

What the manufacturer identifies

Documented conditions; no failure probabilities assigned
ConditionWhat it means for your next step
Drain-hose installation Check routing, visible damage and placement against the Samsung manual, including the required air gap at the standpipe.
Removable filter on a front loader Debris can restrict draining. Samsung top loaders do not have the removable pump filter described in the front-load procedure.

Safe checks before a repair

  1. Stop and let hot water cool

    Turn off and unplug the washer before owner maintenance. Do not force the door or release a full tub onto the floor.

  2. Inspect the visible hose

    Look for crushing or bends. Keep the factory drain-hose holder in place; use an installer if access or rerouting is difficult.

  3. Follow the front-load filter instructions

    If your manual provides access, drain through its emergency tube first with suitable containers, then clean and reseat the filter as directed.

  4. Observe one normal test

    With the filter sealed and the hose correctly installed, restore power. Samsung says the washer should drain at the start of its test cycle; request service if it does not.

Frequently asked questions

Where is the pump filter on my Samsung top loader?

Samsung’s drain guide says top loaders do not have the removable pump filter used in its front-load instructions. Do not dismantle the cabinet to find one.

Does 5C explain why the spin did not start?

It can. Samsung’s spin guide explains that the washer drains before spinning. Address the displayed drain fault first.

Sources: According to the manufacturer. These references are manufacturer guidance, not an independent diagnosis.
Samsung US: Washing machine information and error codes — checked 2026-10-22.
Samsung US: Washing machine will not drain — checked 2026-10-22.
Samsung US: Washing machine does not spin at all — checked 2026-10-22.

Samsung washer error codes

Compare the covered codes and their model limits before choosing another procedure.

Open the reference

Related codes and next steps

Use the page for the actual appliance and display.

Related codes & guides

Error code

LG washer · UE

LG washer UE Error Code

Unbalanced load — the drum can't spin evenly.

Easy fix · 10–20 min
Error code

LG washer · OE

LG washer OE Error Code

Drain error — water isn't draining.

Easy fix · 20–30 min
Error code

LG washer · IE

LG washer IE Error Code

Water inlet error — the tub isn't filling.

Easy fix · 10–20 min
Error code

Samsung washer · LC

Samsung washer LC Error Code

Water level or leak error — water is detected where it doesn't belong.

Moderate
Chart

Washers

LG Washer Error Codes

Browse eighteen LG washer code pages, including distinct Ed1/Ed2 detergent warnings and ezDispense Ed5, with model…

Chart

Washers

Washer Error Codes by Brand

One chart for the common washer problems — drain, fill, unbalanced load, door, leak — and the code LG, Samsung and…

Error code

LG washer · dE

LG washer dE Error Code

The door has not closed or locked as required.

Check model first
Error code

LG washer · LE

LG washer LE Error Code

The tub cannot spin; LG identifies overload or an object in the tub as possible reasons.

Check model first
Error code

LG washer · PE

LG washer PE Error Code

LG reports a problem with the water-level sensor.

Call a pro
Error code

LG washer · tE

LG washer tE Error Code

Heating error; LG associates it with the thermistor that senses temperature.

Call a pro
Error code

Samsung washer · dC

Samsung washer dC Error Code

Model-dependent: a door error or an unbalanced-load error.

Check model first
Error code

Samsung washer · Ub

Samsung washer Ub Error Code

An unbalanced load prevented the cycle from completing.

Check model first
Chart

Washers

Samsung Washer Error Codes

Browse fourteen Samsung washer code pages with AC communication, 3C motor and tC sensing, model-dependent 3E meanings…

Chart

Washers

Whirlpool Washer Error Codes

Compare thirteen Whirlpool front-load code pages for water, doors, balance, foam and dispenser messages, with exact…

Error code

LG washer · Sud

LG Washer Sud Error Code

The washer has detected too much foam and is managing an oversudsing condition.

Check model first
Error code

LG washer · PF

LG Washer PF Error Code

Power was interrupted during operation; the display does not identify why the supply was lost.

Check model first
Error code

LG washer · CE

LG Washer CE Error Code

An overcurrent condition has been detected in the motor’s electrical circuit.

Call a pro
Error code

Samsung washer · OC

Samsung Washer OC Error Code

The washer reports an overflow condition: too much water is detected.

Call a pro
Error code

Samsung washer · 4C2

Samsung Washer 4C2 Error Code

The cold-water supply is unexpectedly hot; Samsung identifies reversed hot and cold connections.

Check model first
Error code

Samsung washer · SUd

Samsung Washer SUd Error Code

Excessive suds were detected; the washer pauses to let the foam settle before continuing.

Check model first
Error code

Whirlpool washer · F5 E1

Whirlpool Washer F5 E1 Error Code

Whirlpool identifies this front-load entry as a door-switch condition.

Check model first
Error code

Whirlpool washer · F5 E3

Whirlpool Washer F5 E3 Error Code

The cited Whirlpool front-load guidance says the door is not locking properly.

Check model first
Error code

Whirlpool washer · F7 E1

Whirlpool Washer F7 E1 Error Code

A motor-speed sensing error: the selected cycle speed is not being achieved.

Check model first
Error code

Whirlpool washer · Sud / Sd

Whirlpool Washer Sud / Sd Error Code

Excess suds are interfering with the wash or spin, so the washer adds rinsing and pauses.

Check model first
Error code

LG washer · dHE

LG Washer dHE Error Code

LG identifies a dry-function error on applicable washer-dryer equipment.

Check model first
Error code

LG washer · AE

LG Washer AE Error Code

The covered LG front-load entry reports internal leakage and activation of the leak-protection system.

Call a pro
Error code

LG washer · SE

LG Washer SE Error Code

LG’s front-load support describes SE as a sensor error requiring service if the limited restart does not resolve it.

Call a pro
Error code

Whirlpool washer · F0 E1

Whirlpool Washer F0 E1 Error Code

A load is detected while the Clean Washer maintenance cycle is selected; Whirlpool also lists rL for this condition.

Check model first
Error code

Whirlpool washer · F0 E5

Whirlpool Washer F0 E5 Error Code

The covered front-load washer reports an off-balance load, which can extend the cycle or reduce spin speed.

Check model first
Error code

Whirlpool washer · F8 E2

Whirlpool Washer F8 E2 Error Code

Whirlpool identifies a problem with the front-load washer’s dispenser system.

Check model first
Error code

Whirlpool washer · F8 E3

Whirlpool Washer F8 E3 Error Code

The washer reports an overflow condition involving too much water or foam.

Call a pro
Error code

Whirlpool washer · dET

Whirlpool Washer dET Error Code

The detergent dispenser cartridge is not detected on applicable cartridge-equipped front-load washers.

Check model first
Error code

LG washer · HE

LG Washer HE Error Code

According to LG, HE reports a heater error on the front-load models covered by its US guide.

Check model first
Error code

LG washer · vS

LG Washer vS Error Code

According to LG, vS concerns the vibration sensor; the display can resemble u5 or uS.

Check model first
Error code

Samsung washer · bE2

Samsung Washer bE2 Error Code

Samsung places bE2 in its stuck-button group, but BE2/8E2 means a MEMS sensor error on some models.

Check model first
Error code

Samsung washer · 9C1

Samsung Washer 9C1 Error Code

According to Samsung, 9C1 belongs to the washer electrical-supply irregularity group.

Call a pro
Error code

Samsung washer · ddC

Samsung Washer ddC Error Code

According to Samsung, ddC or dC3 means the Add Door is not detected as closed and locked.

Check model first
Error code

LG washer · Ed1 / Ed2

LG Washer Ed1 / Ed2 Error Code

LG identifies Ed1 and Ed2 as detergent-dispensing warnings, with different pump conditions reported.

Check model first
Error code

LG washer · Ed5

LG Washer Ed5 Error Code

LG identifies Ed5 as a communication problem involving the automatic detergent dispenser and its control system.

Check model first
Error code

Samsung washer · AC

Samsung Washer AC Error Code

Samsung lists AC as a washer communication error; the exact model determines the affected system.

Check model first
Error code

Samsung washer · 3C

Samsung Washer 3C Error Code

Samsung identifies washer 3C as a motor error. It does not by itself identify a failed motor or sensor.

Check model first
Error code

Samsung washer · tC

Samsung Washer tC Error Code

Samsung lists washer tC, tE and tE1 in its temperature-sensor error group.

Check model first

Other codes